Switch, D-link Gigabit switch D-link DGS-1008D. 8-Port 10/100/1000Mbps. Gigabit Etherne..

Udgiver: John S.

Pris: 140 kr.

Adresse: Ørnebjergvej 53 3650 Ølstykke

2015-25-09

Udsigt: 19

Løbenummer：521zgl3x

Når du kontakter os, så fortæl mig, at du se de oplysninger fra datezr.com.

Billeder

Klik på billedet for at forstørre

Switch, D-link Gigabit switch

D-link DGS-1008D. 8-Port 10/100/1000Mbps. Gigabit Ethernet Switch
OBS: Aldrig brugt, helt ny.
Model: DGS-1008D

Features
The DGS-1008D 8-Port 1000BASE-T Gigabit Ethernet Switch was designed for easy installation and high
performance in an environment where traffic on the network and the number of users increase continuously.
• Eight (8) 1000BASE-T Gigabit Ethernet ports
• Cable Diagnostic function at Switch boot
• Supports Auto-Negotiation for 10/100/1000Mbps and duplex mode
• Supports Auto-MDIX for each port
• Support Full/Half duplex transfer mode for 10 and 100Mbps
• Support Full duplex transfer mode for 1000Mbps
• Full wire speed reception and transmission
• Store-and-Forward switching method
• Supports 4K absolute MAC addresses
• Supports 1M Bits RAM for data buffering
• Extensive front-panel diagnostic LEDs
• IEEE 802.3x flow control for full-duplex
• Back pressure flow control for half-duplex
Power Indicator
This green indicator illuminates when the Switch is receiving power.
?? Link / Act
This green indicator illuminates steadily when a port is connected to a station successfully and has
a good link. The indicator will blink to indicate that a port is transmitting or receiving data on the
network.
?? Speed — 100Mbps/amber; 1000Mbps/green; 10Mbps/off
This indicator is amber-colored when the port is connected to a 100Mbps Fast Ethernet station. It is
green when the port is connected to a 1000Mbps Ethernet station. It is not illuminated when the
port is connected to a 10Mbps Ethernet station.
?? Cable Diagnostic - LED Indications
When the Switch is booted, the Cable Diagnostic function is initialized and run. The Cable
Diagnostic function will detect three common faults in an Ethernet cable connecting the Switch to a
remote network device: an open circuit (a lack of continuity between the pins at each end of the
Ethernet cable or a disconnected cable), a short circuit (two or more conductors short-circuited),

Type: Switch
Mærke: D-link Gigabit switch